rain

Laying a  ceramic  or  porcelain tile floor  can be considered a daunting task, but with adequate planning and preparation, this perception can be overcome. Laying one’s own  marble tile  is also much less expensive (and possibly more rewarding) than having it professionally installed. Cost can be minimized by careful planning and preparation. Laying the foundation. An unpleasant question to be faced is “What is your floor made up of?” Plywood is good. But, if you have the typical 1/2″ to 5/8″ particle board on top of a deck made of 2x8s, you have some work to do. After removal of the base trim, the particle board should be pulled up (this is easiest if you first cut it into about 16″ squares)and replaced by plywood. You will need a Skil saw, and if you’re doing the kitchen, you’ll need a “toe-kick saw.” Replace the particle board up to where the  tiles design  will stop. While you have the particle board off, you can inspect the deck to...

Apply a 1⁄8 inch (0.32 cm) layer of adhesive to the wall. Start applying the adhesive in a bottom corner, about 1 tile length away from the bottom and side of the wall, leaving space for the edge  tiles design . Scoop out a golf ball sized amount of adhesive onto a notched trowel, and spread enough adhesive in a thin layer over the wall to hang 2-3  wall tiles  at a time. You may need to move the trowel over the adhesive a few times to ensure that it’s thin and level. Pre-mixed adhesive tends to be less expensive and work well for  marble wall tiles . If you purchased a powder adhesive, mix it according to the directions until it’s the consistency of peanut butter. Use the trowel to add grooves to the adhesive. Hold the trowel at about a 45-degree angle from the wall. Move the trowel horizontally across the wall to make the grooves, applying consistent pressure as you spread. This will create the necessary ridges in the adhesive to allow for the  ...

Spread your mortar. Spread mortar in a small area where you will begin to work. Only work with a roughly 2’x3′ area at a time. You do not want the mortar to have time to set before you can lay your  floor tiles . Using a notched trowel (different sizes may be needed, 3/8″ is a good starting point), spread the mortar between sections that you marked with the chalk line. If the mortar rises up between the  tiles design  (to be flush or nearly flush with the  cement tiles  surface), that means it’s too thick or that the ridges need to be shorter. The mortar should be covering the entire  tiles , if you lift it up after placing it. If when you lift up the  wood   tiles  you see only lines of mortar on the  tiles , then the mortar has dried out too much or the bed is too thin and the height of the ridges must be increased. If using tile sheets, use a trowel with smaller notches. This will keep the mortar from coming up through ...

Tiles  are indispensable decoration material in modern home decoration, and the floor area is large. It is precisely because of a large number of demand has been stimulating the  tiles design  industry to promote the old and bring forth the new, the  marble tiles  on the market is very diverse, the price is also very different. There are two ways to sell  floor tiles : sold by block or sold by square meters. Before purchasing  tiles , you should calculate the area of  wood marble tiles  which needs to be laid before decoration. Some building materials stores have conversion charts. As long as you know the area to be laid, you can find out the number of  tiles  needed. Some conversion charts are simpler, as long as you know the length and width of the area pasted can find the number of  tiles  needed. Some  floor tiles  boxes will also list the size of a box of  tiles . Usually, 640  t...